K-Bar 2000B, K-Bar 2000PB & K-Bar 2000B-16
Insertion Mass Flow
Transmitter User’s Guide

DCN 360211 Rev. C
June 2009

ISO 9001

Preface
This manual is written as a hypertext document with links to the various sections and topics from the Table of Contents below. To view and navigate this manual, you must have the Adobe PDF reader installed on your computer with its corresponding .pdf browser plug-in. Click this link if you need the free Adobe PDF reader.

Much of the manual content for the multipoint systems are shared with its single point versions, the 454FTB and in-line versions the 504FTB/534FTB. All these units share the same sensors, electronics and firmware. Besides the multipoint systems having more sensors, they also have a flow computer to consolidate and process these signals.

Table of Contents

Publication Notices

Terms and Conditions of Sale

System Introduction, K-BAR Multi-Point
Sensor Array (section. AB)

K-BAR System Installation (Section AC)
        Mounting
        Wiring
        Configuration Check List (section M)
        K-BAR-2000PB, Purge (section AG)

Operation with the 155 Flow Computer (Section AD)
        Wiring
        Configuration
        Analog Output
        155 Mass Flow Computer Summary Guide (360204-6.81)

K-BAR Sensor Operation (Section B)
        Scroll, Display, Meters

K- BAR Sensor Program Mode (Section C)
        AO (Section F)
        Totalizer (section H)
        Pulse Mode Totalizer output (section G)
        Data Logging (Section D)
        Relay, SSR assignments (Section K)

Field Calibration (CAL-16)
        Travers, 2440, Pitot
        Stochiometery (section AA)
        Variable CF Setup and Operation (section AK)

K-BAR Sensor Serial Interfaces (Section J)
        Modbus
        USB
        Gateways (section T)
        OPC servers (Section S)

What Does a Thermal Anemometer Measure? (Section L)
        Flow Unit Conversion Chart (180144)

K-BAR Sensor Field Diagnostics (Section E)
        LCD
        Fault Code memory
        Min-Max event Log
        Trend Memory

Advanced Features
        EPA zero-mid-span calibration (section N)
        PID flow controller (section O)
        Purge Cleaning Controller (section P)

References
        Brochure (367522)
        Upload/Download 6.81
        KZ-COMM
        Kurz USB driver installation (451035)
        Firmware Menu State Diagram (342042-1.1)
        Transmitter attached, Field Wiring Diagram (342040)
        Transmitter separate field wiring diagram (342041)
        Sensor Resistance Values (section AL)
        CE Compliance
        IEC published, potentially hazardous area application fundamentals
        Return Material Authorization (RMA)
        Power-on or Boot-up Sequence (section Q)
        Sensor Control (SC) board versions. (section I)
        Conversion of wet to dry flow rate (364018)
        Glossary of Terms (section R)