|
K-BAR
2000B, K-BAR 2000PB and
K-BAR 2000B-16
Insertion Mass Flow
Transmitter User’s Guide
DCN 360211 Rev. D
August 2010
For
B-Series Firmware Version 2.x
ISO 9001
Preface
This manual is written as a hypertext document with links to the
various sections and topics from the Table of Contents below. To view
and navigate this manual, you must have the Adobe PDF reader installed
on your computer with its corresponding .pdf browser plug-in. Click this link if you need the free Adobe PDF reader.
Much of the manual content for the
multipoint systems are shared with its single point versions, the
454FTB and in-line versions the 504FTB/534FTB. All these units share
the same sensors, electronics and firmware. Besides the multipoint
systems having more sensors, they also have a flow computer to
consolidate and process these signals.
Table
of Contents
Publication
Notices
Terms and
Conditions of Sale
System
Introduction, K-BAR Multi-Point
Sensor Array (section. AB)
K-BAR System
Installation (Section AC)
Mounting
Wiring
Configuration
Check List (section M)
K-BAR-2000PB,
Purge (section AG)
Operation
with the 155 Flow Computer (Section AD)
Wiring
Configuration
Analog Output
155
Mass Flow Computer Summary Guide (360204-6.81)
K-BAR
Sensor Operation (Section
B)
Scroll, Display, Meters
K- BAR
Sensor Program Mode
(Section C)
AO (Section F)
Totalizer
(section H)
Pulse
Mode Totalizer output (section G)
Data Logging (Section D)
Relay, SSR
assignments (Section K)
Field Calibration (CAL-16)
Travers, 2440, Pitot
Stochiometery
(section AA)
Variable CF Setup and
Operation (section AK)
K-BAR Sensor Serial
Interfaces (Section J)
Modbus
USB
MFTB
HART Interface Guide (section AO)
MFTB
HART Wireless Interface Guide (section AU)
Gateways (section T)
OPC servers (Section S)
What
Does a Thermal Anemometer Measure? (Section L)
Flow
Unit Conversion Chart (180144)
K-BAR Sensor Field Diagnostics
(Section E)
LCD
Fault Code memory
Min-Max event Log
Trend Memory
Event
Code Definitions (section AV)
Advanced Features
EPA zero-mid-span
calibration (section N)
PID flow controller
(section O)
Purge Cleaning
Controller (section P)
References
Brochure (367522)
Upload/Download
6.81
MFTB 2.x
Menu Table (section AT)
KzComm (280128)
Kurz USB
driver installation (451035)
Transmitter
attached, Field Wiring Diagram (342040)
Transmitter
separate field wiring diagram (342041)
Sensor Resistance
Values (section AL)
HART DD Menu
Tree (section AP)
HART Field Device
Specification (section AQ)
EC Declaration
IEC published,
potentially hazardous area application fundamentals
Return Material Authorization (RMA)
Power-on
or Boot-up Sequence (section Q)
Sensor Control
(SC) board versions. (section I)
Conversion of wet
to dry flow rate (364018)
Glossary of Terms (section R)
|
